I am proud to share before you a small successful experiment done by me with a Mosquito Bat.
This experiment results in saving energy by sharing of energy. A recycle process.
The image is of a mosquito bat.
This bat is used to kill mosquitoes with the electric charge. The bat should be charged before use and it takes a long time for charging.
When the switch is ON electric charge flows through the mesh of the bat. There are two layers of mesh in this bat. Thick outer layer and Thin Inner layer. Mosquito dies if mosquito touches both the layer at the same time.
But mosquito won't come and sit on the bat. We usually wave the bat to hit the mosquito.
So the time except hitting the mosquito when the switch is ON, will have loss of charge.
My Aim :- Save Energy
This is a simple thing to do and we can save energy.
What I did?
The charge that flows through the mesh when the switch is ON is huge to kill an insect like mosquito. Only a small amount of charge is required to kill a mosquito. So I connected two wires from the mesh to the charging point of the bat. Now the bat can be used for killing mosquito, at the same time the bat gets recharged when the switch is ON. Giving the connection from mesh to charging point reduces the power flowing through mesh but its enough to kill a mosquito.
The photograph below explains the experiment.
I took two wires and here in the picture I connected red wire to the outer layer of the mesh and blue wire to the inner layer of the mesh. Make sure that both wires touch only the respective layers.
This the charging point of the bat. I connected red wire to one point and blue wire to the other.
Now the connection looks like this.
Turn ON the switch and start attacking the mosquito.
Both red light and green light turns on at the same time.
Red light indicated by red arrow states that the charge is flowing through mesh.
Green light indicated by green arrow indicates the bat is getting charged.
This worked for me and I am successfully using this.
Advantage : Charge of the bat is extended by doing this method.
You also can also try this and save energy.
Save ENERGY.
Please share this post if you like.
**NB: Make sure the connections are proper and insulated. Be careful while experimenting.
Bat should be charged again once the power is low, but charge of bat is extended for some more time.
**NB: You can try this at your own risk. I will not be responsible for any damage.
Thank God,
RAM
Great idea... good one too... all the best..wishing you all the success in future... GOD bless you..:)
ReplyDeleteThank you Supriya... :)
ReplyDelete